| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE POWER CORD FROM THE CORD HOOK.
|
| 2 |
|
UNHOOK THE VAC HOSE FROM THE HOSE HOOK.
|
| 3 |
|
LOCATE THE BUTTON ON THE BACK OF THE MACHINE. SLIDE THE BUTTON TO OPEN.
|
| 4 |
|
LIFT UP ON THE UPPER ASSEMBLY TO REMOVE IT FROM THE BASE.
|
| 5 |
|
SLIDE UP ON THE BAG COVER LATCH. PULL THE BAG COVER FROM THE MACHINE.
|
| 6 |
|
PUSH IN ON THE RED LEVER ON THE RIGHT SIDE TO UNLOCK THE BAG.
|
| 7 |
|
PULL THE BAG DOWN OFF THE INTAKE HOSE.
|
| 8 |
|
REMOVE THE 4 SCREWS HOLDING THE UPPER VAC HOUSING.
| Screwdriver-phillips |
|
|
| 9 |
|
PULL THE UPPER VAC HOUSING UP TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 10 |
|
LOOSEN THE 2 SCREWS HOLDING THE GUIDE HOUSING.
| Screwdriver-phillips |
|
|
| 11 |
|
PULL UP ON THE TOP OF THE MIDDLE VAC HOUSING TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 12 |
|
REMOVE 1 SCREW HOLDING HOSE SUPPORT TO THE LOWER VAC HOUSING.
| Screwdriver-phillips |
|
|
| 13 |
|
PULL TO REMOVE HOSE SUPPORT.
|
| 14 |
|
LOCATE THE CURVE SUPPORT IN THE LOWER VAC HOUSING.
|
| 15 |
|
REMOVE THE 2 SCREWS HOLDING THE CURVE SUPPORT TO VAC HOUSING.
| Screwdriver-phillips |
|
|
| 16 |
|
PULL THE HOSE APART TO SEPARATE THE 2 PIECES.
|
| 17 |
|
PULL THE BOTTOM HOSE AWAY FROM CURVE SUPPORT.
|
| 18 |
|
TRACE THE WIRES FROM THE CURVE SUPPORT TO THE TERMINAL BLOCK ON THE MIDDLE VAC HOUSING. LOOSEN THE 3 SCREWS ON THE TERMINAL BLOCK. 1 YELLOW/GREEN WIRE, 1 BLACK WIRE AND 1 WHITE WIRE. PULL TO REMOVE THE 3 WIRES FROM THE TERMINAL BLOCK.
| Screwdriver-flat tip |
|
|
| 19 |
|
REVERSE STEPS 1 THRU 18 TO REPLACE THE CURVE SUPPORT AND TO REASSEMBLE THE MACHINE.
|